How to configure PTCL DSL router over ethernetDecember 1, 2007 – 9:51 pm by Umair Safdar After writing an article “PTCL broadband internet DSL service“; lot of ptcl dsl subscribers are asking about “Configuring DSL over ethernet” so I decided to write a detailed article.
Please note that, this configuration is only applicable to ZTE ZXDSL 831D modem which is provided by ptcl (in white color). I am not covering the ethernet installation and DSL cable connections in this guide because I assume that it is already installed and configured.
Please follow the instructions for step by step configuration.
Point your internet explorer or firefox browser to 192.168.1.1 Login using ZXDSL as username and ZXDSL as password or user and pass both adminClick on “connection settings” in left menu Delete all connections except default one named “rfc139“ Click on “create new connection” Choose “PPP over Ethernet” Press “goto next step”Connection settings are as follows:
VPI: 0 VCI: 103 QoS: UBR Authentication: NONE username: 042XXXXXXX password: XXXXXXXXXXX Click “Create this new service” Click on”Advance Settings” in left menu Then click on security in sub-menu Look for the “Security Interface” and then click on add interface Select ppp-0 and then click on Apply Click on “Enable NAT to Internal Interface” Click on “Maintenance” in left menu, choose”Save” and press the save button Click on “Restart” and press restart button (do not check reset to factory default) For Windows:
Right Click “My Network Places” on desktop and select “Properties” Right Click “Local Area Connections” andselect Properties In the General Tab; double click on”Internet Protocol (TCP/IP)” and made the following settings:
Press OK and enjoy the broadband experience!!
For Linux:
edit /etc/resolv.conf and write:
nameserver 203.135.0.70nameserver 203.135.1.117
Save, exit and enjoy!
http://www.zimbio.com/member/phpgurru/articles/624890/How+configure+PTCL+DSL+router+over+ethernet
00923455228166 umair
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment